#Allen bradley 9300 usbs driver how to
You use these numbers to specify how to move out of the module, then you specify where you are moving to by either specifying the DH+ station number, ControlNet address, or the IP address of another Ethernet module. When in a module, an entry of 1 will always take you to the backplane.ĮNET, ENBT, and EN2T: Exiting 1 = Backplane 2 = Ethernet Port Entering IP AddressĬNB: Exiting 1 = Backplane 2 = ControlNet Port Entering ControlNet AddressĭHRIO Exiting 1 = Backplane 2 = DH+ Channel A 3 = DH+ Channel B Entering DH+ Station Number (an octal value between 0-77) Below is a list of different kinds of modules and what numbers you specify in the connection path when you are exiting or entering those modules. Ethernet modules have Ethernet ports and an IP address ControlNet modules have ControlNet Ports and ControlNet addresses DHRIO modules have channels and station numbers. You can only move in two directions once you are "in" a module: out to the backplane or out through the module port/channel. How you specify your exit point from a module differs depending on which module type you are using. Specify processor slot number or the slot number of the module you wish to exit through.Ĭonnection Path Entries for Different Module Types.Specify address of entry point (DH+ Station Number / ControlNet Address / IP Address of Ethernet module).Specify the slot number of the module you are moving to.This process may sound complicated at first but after some practice it will get easier. Finally you specify the address of your entry point to the next module and the process starts all over again. You then specify the slot of the module you wish to move to, followed by the port or channel of that module that you wish to exit through. The first entry in any connection path will be a 1, which specifies moving to the back plane. The slot number of this module doesn't matter and there is no need to specify it in the connection path. You merely have to follow the path and build the connection path as you go. The first connection point between Ignition and the device is a ControlLogix Ethernet module such as an ENET, ENBT or EN2T module. It is a path that when followed will lead a processor residing in a numbered slot of a chassis somewhere on site. Follow the PathĪ connection path is exactly what it sounds like.
![allen bradley 9300 usbs driver allen bradley 9300 usbs driver](https://cdn.shopify.com/s/files/1/0261/9414/9464/products/A06B-6240-H209_1024x1024.jpg)
For more specific information on individual device types, see the individual connection pages. The following is a basic outline for figuring out your connection path. With there being nearly an endless number of ways to route your connection from device to device it is impossible to give an example of every possible connection path, but in general there is a pattern to how the connection path is specified. The connection path is unique to your setup and is dependent on what modules the connection is being routed through. That is, connections to ControlLogix, CompactLogix, PLC-5, MicroLogix and SLC Allen-Bradley processors bridged through a ControlLogix Gateway require a connection path.
![allen bradley 9300 usbs driver allen bradley 9300 usbs driver](https://i.ebayimg.com/thumbs/images/g/eTEAAOSwCLJgmLD9/s-l200.jpg)
#Allen bradley 9300 usbs driver drivers
All of the Allen Bradley drivers have a Connection Path property that is used when the device uses a special Ethernet card (instead of having an Ethernet connection built in) or if you are using another device to act as a bridge.